Installation: 1. Choose a desired permanent location. Consider utilizing the back side of any cabinet door, but be careful to avoid interference when closing the door. 2. Clean and dry FLAT surface contact area before application. 3. Temporarily secure holder with scotch tape, then insert brushes at neck. 4. Check for easy access, comfort and removability of all brushes. 5. Check all clearance height, length, width & depth. 6. Use a pencil to mark holders’ position. 7. Remove one adhesive tape line and adhere to back of holder where indicated. 8. Remove remaining tape liner and carefully adhere holder into position. Press firmly. 9. With proper use, Holder will last a lifetime. Suggestions: Additional holders may be applied side by side. The use of a level may help but is not necessary. Caution: Do not affix holder to the back of a mirrored cabinet door that has exposed silver plating. Not intended to suspend the weight of a battery powered brush; however, a single rung may be trimmed off with a household scissors to stabilize and secure a rested battery brush to prevent it from falling.
If you would like to make a comment, please fill out the form below.
